Cut Hyprland's idle GPU use, fan noise and battery drain from blur
Most of this is confirmed, some of it verbatim. The Performance wiki's fractional-scaling advice is character-for-character the record's monitor line: 'try setting the scaling to integer numbers such as 1 or 2 like in this example hl.monitor({ output = "", mode = "preferred", position = "auto", scale = 2 })'. The TLP section matches too, including the exact keys INTEL_GPU_MIN_FREQ_ON_AC / _ON_BAT in /etc/tlp.conf and the 300->500 bump. The blur/shadow disable lines match the wiki's 'Useful Optimizations'. Every blur sub-option is real (new_optimizations 'Recommended to leave on, as it will massively improve performance', xray 'Only available if new_optimizations is true', special 'note: expensive', popups). config/hypr/looknfeel.lua does exist in the omarchy repo as a user override file. The error is in the cause paragraph: it attributes continuous full-refresh-rate rendering to blur, and then attaches the wiki's 'even when animations are disabled or the decoration is not visible' warning to that claim. That warning belongs solely to *angle loop animations. The Animations wiki says: 'Using the loop style for *angle animations requires Hyprland to constantly render new frames at a frequency equal to your screen's refresh rate... This will apply even if animations are disabled or the affected decorations are not visible.' Blur is expensive per frame but does not force frames. Conflating them will send someone hunting the wrong thing.
Symptom
Hyprland feels laggy, the fans spin up while idle, or the laptop's battery drains noticeably faster than under a plain WM. GPU usage sits high with nothing on screen.
Cause
Two different costs, worth separating. *angle animations using the loop style force Hyprland to render new frames continuously at the monitor's refresh rate, and the wiki warns this applies even when animations are otherwise disabled or the affected decoration is not visible. Blur (including blur on the special workspace and popups) and shadows are expensive *per frame* but do not by themselves force frames to be drawn. Fractional monitor scaling adds further GPU cost. On Intel iGPU laptops, TLP's aggressive default GPU floor causes stutter independent of Hyprland.
Fix
All the settings are correct. Only the cause needs splitting into its two distinct mechanisms, because they have different fixes:
*angleloop animations (borderangle / shadowangle / glowangle with style = "loop") are the ones that force continuous rendering at your full refresh rate. The wiki's warning is specific to these: it applies 'even if animations are disabled or the affected decorations are not visible'. This is the one to hunt first on a laptop: it burns GPU on a completely idle screen.
grep -rnE 'borderangle|shadowangle|glowangle' ~/.config/hypr/
Remove any loop style. The default is once.
- Blur and shadows do NOT force frames. They make each frame more expensive. They cost you when something is actually redrawing. Disable or tune them as the record shows (the blur { new_optimizations = true, xray = true, special = false, popups = false } block is correct and matches the wiki's own notes).
- Fractional monitor scale and the Intel iGPU + TLP floor are separate, independent causes, both as the record describes.
On Omarchy, ~/.config/hypr/looknfeel.lua is the right place. It is a shipped user override file.
Verify
hyprctl getoption decoration:blur:enabled reports 0. GPU utilisation drops to near zero on an idle desktop (intel_gpu_top / nvtop / radeontop).