OPINIONATED OMARCHY
TROUBLESHOOTING CORPUS
790
RECORDS
790
AUDITED
0
UNCHECKED
2388
SOURCES
LIVE
power-suspend medium common DISPUTE

Quiet a hot, loud Intel laptop by running thermald

archomarchyendeavouroscachyosmanjarolaptopintel
CORRECTED An auditor found the fix wrong or incomplete and rewrote it.
AUDIT NOTE

The thermald half is accurate: Arch ships no thermal daemon by default, thermald is Intel-only, and thermald plus lm_sensors are the correct Arch package names (lm_sensors with an underscore). The AMD guidance is fine. The problem is the closing sudo powertop --auto-tune presented as a diagnostic step for finding a runaway process. It is not diagnostic at all: it immediately applies every tunable, including USB autosuspend and SATA link power management, which is precisely the breakage the USB-autosuspend record in this same set is about: crackling DACs, dropped Bluetooth, stuttering mice, and on some machines a wedged input device. Telling the reader to 'inspect the Tunables tab before trusting it' after the flag has already applied everything is backwards ordering.

The cause above was not rewritten and may still contain the error described. The fix below is the corrected version.
RISK

powertop --auto-tune enables every tunable including SATA/USB power saving, which can make mice, keyboards and external drives misbehave. Review the Tunables tab and apply selectively.

Symptom

The laptop runs noticeably hotter and the fan ramps far more aggressively on Arch/Omarchy than it did on Windows or Fedora, with no obvious runaway process.

Cause

Arch installs no thermal daemon by default. On Intel machines, thermald proactively manages P-states, T-states and the powerclamp driver to keep the package (and, where a skin sensor exists, the chassis) below target before the hardware falls back to aggressive throttling. Without it the firmware's blunt corrections drive the fan curve.

Fix


sudo pacman -S thermald lm_sensors
sudo sensors-detect --auto
sudo systemctl enable --now thermald.service

Watch the effect:


watch -n2 sensors

On AMD, thermald does not apply. Use power-profiles-daemon (or TLP, never both) and the EPP hint:


sudo systemctl enable --now power-profiles-daemon.service
powerprofilesctl set balanced

To find a runaway process, run powertop READ-ONLY first. Do not use --auto-tune as a diagnostic. It applies every tunable immediately, including USB autosuspend and SATA link power management, which is a well-known way to break USB audio, Bluetooth and input devices:


sudo pacman -S powertop
sudo powertop --calibrate      # optional, for accurate power estimates; screen will flicker
sudo powertop                  # interactive: check Overview and Tunables tabs

Apply tunables one at a time from the interactive Tunables tab (Enter toggles the highlighted one) and test after each. Only consider --auto-tune on a headless machine with no USB peripherals you care about, and note it is not persistent across reboots by itself.

Also check the obvious causes before blaming the thermal stack:


top -o %CPU
cat /sys/devices/system/cpu/cpufreq/boost      # 1 = boost enabled

Verify

systemctl status thermald is active. sensors shows the package temperature settling lower under sustained load and the fan stepping down.

Sources

intel-laptop-hot-loud-no-thermald