Bring the laptop panel back after unplugging the external monitor
Symptom
You disabled the laptop panel with Super+Ctrl+Delete to work external-only, then later unplugged the external monitor, and the laptop screen stays completely black. It came back automatically on Omarchy 3.x. hyprctl monitors still lists the monitor you unplugged.
Cause
Omarchy 4's omarchy-hyprland-monitor-internal recover gates on omarchy-hyprland-monitor-external-active, which asks hyprctl monitors all -j. On cable removal Hyprland does not always drop the output from its list immediately, so that check still says an external is active and recover() returns early without deleting the disable toggle or reloading. (Omarchy 3.x checked /sys/class/drm/card*-*/status directly instead.)
Fix
Blindly (screen is black) or from a TTY / SSH session, delete the toggle file and reload:
rm -f ~/.local/state/omarchy/toggles/hypr/internal-monitor-disable.lua
rm -f ~/.local/state/omarchy/toggles/hypr/internal-monitor-clamshell.lua
hyprctl reload
hyprctl dispatch 'hl.dsp.dpms({ action = "enable" })'
Or use the shipped recovery helper, which checks real DRM status rather than Hyprland's cached list:
omarchy-hw-recover-internal-monitor
hyprctl reload
To avoid it recurring, re-enable the panel *before* unplugging (Super+Ctrl+Delete again).
Verify
hyprctl monitors -j | jq -c '.[] | {name, disabled, width, height}' shows eDP-1 present, not disabled, with a non-zero mode, and the panel lights up.