OPINIONATED OMARCHY
TROUBLESHOOTING CORPUS
790
RECORDS
790
AUDITED
0
UNCHECKED
2388
SOURCES
LIVE
audio-input medium common DISPUTE

Fix a microphone that is inaudible or clipped and distorted on calls

omarchyarchendeavouroscachyosmanjarohyprlandwaylandpipewirelaptop
AUDITED Audited against its sources and confirmed accurate.

Symptom

People on calls say you are inaudible, or that you sound blown-out and clipped/static-y. Recordings are either near-silent or heavily distorted even at moderate speaking volume.

Cause

The ALSA Mic Boost / Internal Mic Boost control is at maximum (distortion) or the Capture control is at zero (silence). PipeWire's source volume is a separate, additional gain stage on top of it, so raising one while the other is wrong makes it worse.

Fix

Set the hardware gain sanely first:


alsamixer -c 0

Press F4 for the capture view, then set Mic Boost / Internal Mic Boost to 0 or 1 step, and raise Capture to around 70-80%. Non-interactively:


amixer -c 0 sset 'Mic Boost' 0
amixer -c 0 sset 'Internal Mic Boost' 0
amixer -c 0 sset Capture 75% cap
sudo alsactl store

Then set PipeWire's software gain (values above 1.0 are extra gain, use sparingly):


wpctl set-volume @DEFAULT_AUDIO_SOURCE@ 100%
wpctl set-mute @DEFAULT_AUDIO_SOURCE@ 0

Monitor your own level while adjusting:


arecord -vv --format=dat /dev/null

The bar graph should peak around 60-80%, never pinning at the right edge.

Verify

arecord -vv --format=dat /dev/null shows peaks in the upper-middle of the meter while speaking normally, and a test recording plays back clean.

Sources

microphone-too-quiet-or-distorted